Cursor dosent show up in the PE

[karl1poiss]

Setup:

• Which version of Windows you chose - Windows 10
• Raspberry Pi model - Raspberry Pi 400
• Name of SD card you tried to flash (some are too slow or too small) - Toshiba 16 GB
• What day you first downloaded wor-flasher - Dont remember
• What linux operating system you are using to run wor-flasher on. (Raspberry Pi OS, Twister OS, Debian, etc) - Raspberry Pi OS

Procedure:

Tell us what you did, step by step. Be specific enough so that one of us would be able to replicate your setup.

• Flash the device
• Go to Device Manager and under there Raspberry Pi Settings
• Set resolution to 720p and turn off native resolution
• Turn off 3 GB ram limit
• Save and boot the PE

[karl1poiss]

Also, this happened when I decided to reinstall the WOR-Flasher because I thought that the PE was not installing the OS (it was, and very very very slowly.)

[lolimjustherefornoreason]

Same here when I was in the installer

[Botspot]

Try updating the bootloader.

[lolimjustherefornoreason]

I'm a beginner at this stuff so I don't understand how to update the bootloader

[lolimjustherefornoreason]

And when I booted to Installer it was showing to plug in a storage to install to even though I was using a 64 GB Usb stick which can install Windows on itself

[Argetlam3]

Having this issue as well. My mouse isn’t showing up, I’m going to troubleshoot and will see what happens

[WombleWoo7547]

If anyone is still here, to update the bootloader, boot into Raspberry Pi OS (lite or desktop). In a terminal, type in:

rpi-eeprom-update

and follow the instructions.