Turn Off OSPF for specific Interface

[connectlifeit]

Hello, I have been using FRR for a few days. I have activated the OSPFv2 daemon and it is working fine. The problem is that if I insert a class of IP in the networks, the OSPF is also activated for the interface concerned. Example:

network 185.1.114.0/24 area 0.0.0.0

185.1.114.0/24 is on the ens225 interface

The ens225 interface is connected to my UPSTREAM for BGP sessions

This network is in OSPF to announce it to the other routers but I don't want OSPF to activate on ens225 because otherwise HELO packets arrive at my UPSTREAM.

If I remove the network from the configuration:

ens225 is up
ifindex 56, MTU 1500 bytes, BW 10000 Mbit <UP, BROADCAST, RUNNING, MULTICAST>
OSPF not enabled on this interface

Is this normal behavior?
Thank you

[donaldsharp]

  (interface)  [no] isis passive
  (interface)  ip ospf passive [A.B.C.D]
  (interface)  ip pim [passive]
  (interface)  ipv6 ospf6 passive
  (interface)  ipv6 pim [passive]
  (interface)  no openfabric passive
  (interface)  no ip ospf passive [A.B.C.D]
  (interface)  no ip pim [passive]
  (interface)  no ipv6 ospf6 passive
  (interface)  no ipv6 pim [passive]
  (interface)  openfabric passive
  (rip)  [no] passive-interface IFNAME
  (rip)  [no] passive-interface default
  (ripng)  [no] passive-interface IFNAME
  (eigrp)  [no] passive-interface IFNAME
  (bgp)  neighbor <A.B.C.D|X:X::X:X|WORD> passive
  (bgp)  no neighbor <A.B.C.D|X:X::X:X|WORD> passive
  (ospf)  no passive-interface IFNAME [A.B.C.D]
  (ospf)  no passive-interface default
  (ospf)  passive-interface IFNAME [A.B.C.D]
  (ospf)  passive-interface default
  (bfd peer)  [no] passive-mode
  (bfd profile)  [no] passive-mode
eva#