You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I thought this one was already created. But I don't see it in the repository.
I think it would look something like
Source.Angle or Source.PlaneAngle
I think the angle is measured on a 2-dimensional plane.
Degrees would be the primary unit, with conversion to radian, gradian, angular mils
The big question is how different an Angle Block, Angle Gauge, Sine Bar, Sine Plate measurements are.
Would these be a different Type Parameter meaning they are fundamentally the same.
I agree @SchwartzMichael These are fundamentally the same -- the sum of angles on a rotational plane sums to 360 degrees. Parameters may be used to indicate the Type, polygon, sine bar, etc...
Contact Details
[email protected]
What is the process type?
Measure
Measurand
Measurement of a dimensional angle. calibration of Angle Blocks, Angle Gages, Sine Bar, Sine Plates, inclinometers, levels, etc
Kind of quantity
geometric dimensional Angle (as opposed to electrical phase angle)
Does the measurand require a special token?
None
Taxon Name
Measure.Length.Form.Angle
The text was updated successfully, but these errors were encountered: