[R1 Beta] Built-in support is too close (in X/Y) to the TFT35 bezel

[AlejandroRivera]

While printing the TFT35 bezel, I noticed that the clearance with the built-in support wasn't enough to prevent the pieces from being fused together (at least in a Prusa MK4S printing in with PLA using Voron settings).

The support was so fused it had to be cut with a exacto knife. Here's a picture of the result to give you an idea of where the fused edges happened:

I'd recommend increasing the clearance from 0.2mm to 0.3mm