Is lower RAM usage possible?

[ionGL]

All LHM sensors Off, no plugins, only NvApiWrapper.

I control just the gpu with a mix of 2 curves.

Start minimized, notify for update at startup off, no temp tray icons.

I saw 29MB ram usage after a boot.

But after you open the main window and close it to tray, it remains at ~100MB.

Is this a .net thing, not returning to that lower ram usage when the main window was not opened yet? I tried all .net verions and it makes little difference.

I know ram is cheap, but i was wondering if ram usage could be lower in a case like this, when LHM is not needed.

[Rem0o]

If you wait for some time, forget about it, then open Task manager back, you'll see it will go down if you leave the UI closed. That's garbage collection. I don't have complete control over it. Might take 5 minutes, might take 30 minutes, but it will go down eventually.

[Rem0o]

Like this:

[ionGL]

I kept an eye on the 4.8 version since yesterday. Windows restart, waited for it to start in tray, opened it for a few seconds, then back to tray an left it there. Checked task manger from time to time, it didn't move lower than ~85MB.

I'm now testing with 8.0. The thing is i rarely restart windows. I just put it on standby. Once it resumes from standby, i can see in task manager that it jumped to ~136MB. I don't touch it, tested with a 3d load and the gpu curves work like they should. It stays at ~136 and only goes down once the main window is opened, goes to ~98, then in tray stays around that.

I notice that if you open it from tray after a standby, you see the "configuration loaded..." notification.

If you resume from standby and never touch it, it will stay ~136 forever.

[ionGL]

I haven't touched the tray icon since yesterday, no windows restart, a couple standbys, it's not moving lower than 139. Gpu fan control works.

[ionGL]

After another 2 days of leaving it alone in tray, no windows restarts, around 10-15 standbys, it stabilized at ~141MB.

Then when i opened it from tray after a few days, i got the "configuration loaded" notification in the interface many times one after the other. Probably it kept count from the standbys and now it reloaded them all.

Edit: I tried again 2 standbys. Once opened, got 2 "configuration loaded" messages.

[Rem0o]

The configloaded message is normal. There is a queue and it waits for the window to come back to show the messages.