ndppd.conf-dist

# route-ttl <integer> (NEW)
# This tells 'ndppd' how often to reload the route file /proc/net/ipv6_route.
# Default value is '30000' (30 seconds).

route-ttl 30000

# proxy <interface>
# This sets up a listener, that will listen for any Neighbor Solicitation
# messages, and respond to them according to a set of rules (see below).
# <interface> is required. You may have several 'proxy' sections.

proxy eth0 {
   
   # router <yes|no|true|false>
   # This option turns on or off the router flag for Neighbor Advertisement
   # messages. Default value is 'true'.
   
   router yes

   # timeout <integer>
   # Controls how long to wait for a Neighbor Advertisment message before 
   # invalidating the entry, in milliseconds. Default value is '500'.

   timeout 500   
   
   # ttl <integer>
   # Controls how long a valid or invalid entry remains in the cache, in 
   # milliseconds. Default value is '30000' (30 seconds).
   
   ttl 30000

   # rule <ip>[/<mask>]
   # This is a rule that the target address is to match against. If no netmask
   # is provided, /128 is assumed. You may have several rule sections, and the
   # addresses may or may not overlap.

   rule 1111:: {
      # Only one of 'static', 'auto' and 'interface' may be specified. Please
      # read 'ndppd.conf' manpage for details about the methods below.

      # 'auto' should work in most cases.

      # static (NEW)
      # 'ndppd' will immediately answer any Neighbor Solicitation Messages
      # (if they match the IP rule).

      # iface <interface>
      # 'ndppd' will forward the Neighbor Solicitation Message through the
      # specified interface - and only respond if a matching Neighbor
      # Advertisement Message is received.
      
      # auto (NEW)
      # Same as above, but instead of manually specifying the outgoing
      # interface, 'ndppd' will check for a matching route in /proc/net/ipv6_route.

      auto

      # Note that before version 0.2.2 of 'ndppd', if you didn't choose a
      # method, it defaulted to 'static'. For compatibility reasons we choose
      # to keep this behavior - for now (it may be removed in a future version).
   }
}