fans.cfg

#####################################################################
#	Fan Control
#####################################################################

[heater_fan hotend_fan]
##	Hotend Fan - FAN0 Connector
pin: PB0
max_power: 1.0
kick_start_time: 0.5
heater: extruder
heater_temp: 50.0
##	If you are experiencing back flow, you can reduce fan_speed
#fan_speed: 1.0

[fan]
##	Print Cooling Fan - FAN1 Connector
pin: PB1
max_power: 1.0
cycle_time: 0.01
kick_start_time: .5
##	Depending on your fan, you may need to increase this value
##	if your fan will not start. Can change cycle_time (increase)
##	if your fan is not able to slow down effectively
off_below: 0.10

[controller_fan controller_fan]
##	Controller fan - FAN2 Connector
pin: PB2
kick_start_time: 0.5
heater: heater_bed
fan_speed: 0.2

[fan_generic exhaust]
pin: PB6
max_power: 1.0
shutdown_speed: 0.0
kick_start_time: 5.0


[heater_fan nevermore]
pin: PB5
max_power: 1.0
shutdown_speed: 0.0
kick_start_time: 5.0
heater: heater_bed
heater_temp: 45
fan_speed: 1.0