Replies: 4 comments
-
|
Thank your for submiting, please be sure you followed template or your issue may be dismissed. if you deleted the template it is here |
Beta Was this translation helpful? Give feedback.
-
|
did you checked the wiki ? it has entry for smoothieware board |
Beta Was this translation helpful? Give feedback.
-
|
you do not need any level converter if you use 3.3v board / power supply, not all boards are 3.3v, several boards like mega ramps ard 5v and need logic shifter / diode / resistor |
Beta Was this translation helpful? Give feedback.
-
|
why https://github.com/luc-github/ESP3D/wiki/Smoothieboard is wrong ? picture come from smoothieware itself |
Beta Was this translation helpful? Give feedback.
-
Hello,
looking about how to connect ESP-12 or ESP-01 to the smoothieboard I went over
https://github.com/luc-github/ESP3D/wiki/Smoothieboard
I found that with JP5 all would be fine with TX0 and RX0 but wondering, that there should be a level conversion between ESP-xy and µC, while the µC on smoothieboard also works with 3V3. So looking in the schematic
https://smoothieware.org/smoothieboard-schematic
there you can see, that it is like I suggested.
By simply switch JP5 Pin 3 with SJ1 to 3V3 all will be fine with JP5 supporting an ESP01 or ESP12 directly with 3V3 and the correct 3V3 level with RX_0 and TX_0 from the LPC1769. So there is definitely no need for any level translators nor any 3V3 voltage regulators as requested
here
https://github.com/luc-github/ESP3D/wiki/ESP8266-01 and
https://github.com/luc-github/ESP3D/wiki/ESP8266-12E-F and
https://github.com/luc-github/ESP3D/wiki/ESP-32-CAM with RX using two resistors
also
https://github.com/luc-github/ESP3D/wiki/D1-mini there is no need for level converter
Am I wrong or why these Resistors / level-conversion?
Regards
Marte
Beta Was this translation helpful? Give feedback.
All reactions