Replies: 3 comments
-
For me these Oventrop Devices are working fine, I have defined them one by one in the the devices file. Get the address from the log file! Sorry for me only the temp is relevant example: [thermostat_wohnzimmer] |
Beta Was this translation helpful? Give feedback.
-
Thanks for your reply. |
Beta Was this translation helpful? Give feedback.
-
Well my installation is Enocean R-Tronic RT B and R-con with Wibutler Enocean controller which was setup as part of our new heat pump. As Wibutler is a closed smart home system I am still interested in getting some data out of it into Home Assistant. But the controller is Wibutler. Reading data with enoceanMQTT is rather simple as far as I have understood but sending data or commands needs additional definitions you may find examples for switches/buttons in the wiki here. I have not tried this. |
Beta Was this translation helpful? Give feedback.
-
I need support on how to integrate my Oventrop R-Tronic RT B in this integration.
In the manual it says, that several EEP`s are supported manual. For me only the temperature and the setpoint are relevant so i think A5-10-06 should be the correct one. In general the EEP is working well and the values seem are correct but i am not able to send the setpoint from HA to the device. when i publish a new setpoint via mqtt it is shown correct in the HA entity but it is overwritten with the next sending interval from the device.
On the enocean homepage i have also found the device and here it says that it uses the A5-20-01 EEP but this doesnt work too and also the temperature values are not correct. link
Any idea how i can achieve this ?
Thanks in advance!
Beta Was this translation helpful? Give feedback.
All reactions