-
Notifications
You must be signed in to change notification settings - Fork 3
/
gdbinit
61 lines (57 loc) · 2.74 KB
/
gdbinit
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
#*****************************************************************************
# gdbinit
#
# Initilization script for GDB for ARM
#
# Copyright (C) 2014 Texas Instruments Incorporated - http://www.ti.com/
#
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
#
# Redistributions of source code must retain the above copyright
# notice, this list of conditions and the following disclaimer.
#
# Redistributions in binary form must reproduce the above copyright
# notice, this list of conditions and the following disclaimer in the
# documentation and/or other materials provided with the
# distribution.
#
# Neither the name of Texas Instruments Incorporated nor the names of
# its contributors may be used to endorse or promote products derived
# from this software without specific prior written permission.
#
# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
# "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
# LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
# A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
# OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
# SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
# LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
# DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
# THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
# (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
# OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
#
#*****************************************************************************
#*****************************************************************************
# Connect To the target using OpenOCD
#*****************************************************************************
target remote | openocd -c "gdb_port pipe; log_output openocd.log" -f cc3200.cfg
#*****************************************************************************
# Load the binary
#*****************************************************************************
monitor soft_reset_halt
load
#*****************************************************************************
# Initialize the SP and PC values from the application's
# vector table
#*****************************************************************************
set $sp = *(int *)0x20004000
set $pc = *(int *)0x20004004
#*****************************************************************************
# Set break point at start and run to start
#*****************************************************************************
break start
continue