config_RFM69.h

/*  
  OpenMQTTGateway  - ESP8266 or Arduino program for home automation 

   Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal  and a MQTT broker 
   Send and receiving command by MQTT
 
   This files enables to set your parameter for the radiofrequency gateways (ZgatewayRF and ZgatewayRF2) with RCswitch and newremoteswitch library
  
    Copyright: (c)Florian ROBERT
  
    This file is part of OpenMQTTGateway.
    
    OpenMQTTGateway is free software: you can redistribute it and/or modify
    it under the terms of the GNU General Public License as published by
    the Free Software Foundation, either version 3 of the License, or
    (at your option) any later version.

    OpenMQTTGateway is distributed in the hope that it will be useful,
    but WITHOUT ANY WARRANTY; without even the implied warranty of
    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
    GNU General Public License for more details.

    You should have received a copy of the GNU General Public License
    along with this program.  If not, see <http://www.gnu.org/licenses/>.
*/

/*----------------------RFM69 topics & parameters -------------------------*/
#define subjectRFM69toMQTT "home/RFM69toMQTT"
#define subjectRFM69toMQTTrssi "home/RFM69toMQTT/rssi"
#define subjectRFM69toMQTTsender "home/RFM69toMQTT/sender"
#define subjectMQTTtoRFM69 "home/commands/MQTTtoRFM69"
#define RFM69receiverKey "RCV_" // receiver id will be defined if a subject contains RFM69receiverKey followed by a value of 3 digits
#define subjectGTWRFM69toMQTT "home/RFM69toMQTT"
#define defaultRFM69ReceiverId 99

// Default values
const char PROGMEM ENCRYPTKEY[] = "sampleEncryptKey";
const char PROGMEM MDNS_NAME[] = "rfm69gw1";
const char PROGMEM MQTT_BROKER[] = "raspi2";
const char PROGMEM RFM69AP_NAME[] = "RFM69-AP";
#define NETWORKID     200  //the same on all nodes that talk to each other
#define NODEID        10

//Match frequency to the hardware version of the radio
#define FREQUENCY     RF69_433MHZ
//#define FREQUENCY     RF69_868MHZ
//#define FREQUENCY      RF69_915MHZ
#define IS_RFM69HCW    true // set to 'true' if you are using an RFM69HCW module
#define POWER_LEVEL    31

/*-------------------PIN DEFINITIONS----------------------*/

#ifdef RFM69_Wiring // Without Support for I2C Modules and HM10 or 11
  
  #ifdef ESP8266
    #define RFM69_CS      D1  // GPIO5/HCS/D1
    #define RFM69_IRQ     D8   // GPIO15/D8
    #define RFM69_IRQN    digitalPinToInterrupt(RFM69_IRQ)
    #define RFM69_RST     D4   // GPIO02/D4
  #else
    //RFM69 not tested with arduino
    #define RFM69_CS      10
    #define RFM69_IRQ     2
    #define RFM69_IRQN    digitalPinToInterrupt(RFM69_IRQ)
    #define RFM69_RST     9
  #endif
#endif