You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The wiring cutouts in the top panel of the electronics corner are extremely tight if one sleeves the cables and runs additional cables through the cutouts.
I have the cords for PanelDue, front stepper, and a filament out sensor all running through the front slot. All are sleeved, and they end up pinched in fairly tightly. Expanding this slot a little bit would be a big help for people with similarly built-out machines.
The text was updated successfully, but these errors were encountered:
On Thu, Sep 19, 2019 at 7:21 AM Dan White ***@***.***> wrote:
What sort of size would you suggest?
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#12?email_source=notifications&email_token=ABYQQ43X23HEOHEEH24TZDLQKNOC3A5CNFSM4HNZL5DKYY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOD7DEAYA#issuecomment-533086304>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/ABYQQ42M3FHCLMZJN3N2P7LQKNOC3ANCNFSM4HNZL5DA>
.
I think just expanding the radius of the cutouts from 7.5mm to 10mm would get the job done and not make the holes seem excessive.
If I were messing with that part, I would also see what it looks like to put a small (like 1mm) radius on the currently-sharp ends of that slot, just to eliminate a sharp point that can snag wires during assembly.
The wiring cutouts in the top panel of the electronics corner are extremely tight if one sleeves the cables and runs additional cables through the cutouts.
I have the cords for PanelDue, front stepper, and a filament out sensor all running through the front slot. All are sleeved, and they end up pinched in fairly tightly. Expanding this slot a little bit would be a big help for people with similarly built-out machines.
The text was updated successfully, but these errors were encountered: