Full config loss after power cycle / USB Disconnect

[b14ckyy]

I just started to look at the U360GTS project again as I want to start to use it regularly now. Installed 11.2.0 RC2 with full chip erase and set up from scratch.

I had multiple full config losses when I switched from USB to Battery power. It was hard to replicate manually. One time it happened after the following steps:

• changed settings
• clicked save > system reboots
• clicked disconnect > system reboots again
• removed USB > powers off
• Powered on by battery > no display shown
• connected USB > all config lost and all on default

I have then left the new Last Home Safe option off. Since then I had a lot of power cycles and no issue. Can' completely validate yet but it might have something to do with the last home b8ackup function.

Board: SPRF3; separate BECs for Servos and Board

[b14ckyy]

Update: Again full config loss just by switching battery power off, and after a few seconds on again.,.. so it is not the last home store option. I have no idea....

[ModaFpv]

same with you......