Minimum and Maximum Target Temperature

[bjappler]

Would it be possible to set a minimum and maximum target temperature instead of using 0,5 1 and 2 C in faikin automatic modus?
The automatic mode should work as follows:

If the temperature falls below the minimum temperature, heat up to the maximum temperature. Only heat again when the temperature falls below the minimum temperature.
This would have the advantage that the air conditioning system would have a low cycle rate.

Is this setting already possible or could be a feature update?

It would also be great if the Faikin auto mode only referred to the temperature, but other parameters such as the power of the outdoor unit or ventilation level could be set manually. This would also reduce the cycle rate.

Many thanks in advance.

[revk]

The manual covers the way it works in detail. It has various modes you can set, which cover ways of working like that.

[bjappler]

Would these settings be possible in your faikin http front end? I did not find this in your manuals.

[revk]

All the settings are on the web pages.

There is not a specific min/max but the e 0.5, 1, 2 are a min/max that far each side of the temp you set. Do you need wider than 4C?

The extra settings control how it uses these, and there is definitely stuff in the manual on that.

[bjappler]

I found the variable pushtemp in the instructions. I assume this is what I am looking for, if I have understood it correctly.

Would a value of 2.0 mean that with a target temperature of 20 degrees and Faikin auto mode -+ 2 degrees, the air conditioning heats up to 20 degrees and only heats again when the temperature falls below 18 degrees?

This would be the feature I was looking for!

[revk]

20 +/- 2 means a min 18 and a max 22.

There is a thermostat setting as well. The manual does cover this in some detail, honest.

[bjappler]

This is what I was looking for! Thank you so much for your help and for your patience.