Unable to program ESP32 with latest board rev. #514
Closed
KiloWattWizard
started this conversation in
General
Replies: 1 comment 1 reply
-
|
USB just works, no need to mess with GPIO0, only connection is to the programming pads, with D-, D+, GND, and 5V. |
Beta Was this translation helpful? Give feedback.
1 reply
-
|
Got it thanks. |
Beta Was this translation helpful? Give feedback.
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I'm pretty new to using the ESP32 outside of dev boards, so I might be missing something obvious here.
I have ordered a latest-revision board from JLCPCB and I'm trying to program the firmware. I can't seem to get the ESP32 to respond to programming attempts. I have a USB breakout soldered directly to the pads for USB, and I have verified that I've got +5 and 3.3V on the board.
The Espressif documentation states that you need to pull GPIO0 down and hit reset to get into DFU mode, but these pins are not broken out on the board.
What am I missing?
Beta Was this translation helpful? Give feedback.
All reactions