SBUS to PPM for Futaba Radio Help

[dzaro-dev]

Dear sebseb7,

I couldn't find another way to contact you so I am contacting you like this.

I have the purchased the SBUS to PPM decoder from you and I was hoping that you can help me with the setup.

I have a Futaba T14SG transmitter and a Futaba R7008SB receiver set to "Mode B". Mode B is the mode where CH8 on the receiver becomes the S.BUS port for SBUS servos for example. However, I would like all channels to go through the S.BUS port, i.e. Channels 1 to 8 so that using a decoder, I can convert the S.BUS to a PPM-Combined for channels 1 to 8. I have the decoder wired to channel 8 on the receiver however I am not sure if there is something that I need to do on the transmitter to make this work. As mentioned, the transmitter I am using is a T14SG. I am decoding to PPM because I want to connect to the ImmersionRC Long range transmitter and this only takes PPM as an input. Images are attached below.

I initially thought that I need to register the PPM encoder with the T14SG the way that an SBUS servo is registered, however, I was not successful in my attempts and therefore I am contacting you in hopes that you will be able to explain to me what I am doing wrong and how to do it right.

Thank you in advance for your help!

Images of my intended setup:

[sebseb7]

I do not sell these adapters, this is a clone.

[sebseb7]

I have no idea what kind of software it is running. (mine or theirs)

[sebseb7]

with my software you should have 8 or 12 channels.

[sebseb7]

if you need help contact me:

twitter.com/sebseb7
facebook.com/seb.greenbus