Ardusimple simpleGNSS NEO-F10T module

[semuadmin]

Few points to note for those looking to use the new Ardusimple NEO-F10T 'simpleGNSS' development board with PyGPSClient:

1. Although the board has a USB-C connector, it registers as an FT230X UART1 device, so you'll need ensure the connection baud rate is set to 38400 initially. The F10T itself only has a single UART interface.
2. Many of the legacy CFG commands will no longer work, so use PyGPSClient's CFG-VALSET/GET/DEL Configuration Interface panel to configure.
3. It has aggressive L-Band cutoff filtering around the L1 and L5 bands.
4. My board came with firmware TIM 3.01 installed, protocol version 42.01.
5. Any new configuration database keys will be available in the next PyGPSClient release v1.3.26.