.env

#LiteProtocolTester run configurator

# Docker image of lite-protocol-tester if different than used default
#LPT_IMAGE=

# Define number of publisher and receiver nodes to run.
NUM_PUBLISHER_NODES=1
NUM_RECEIVER_NODES=1


# Can add some seconds delay before SENDER starts publishing
# Useful to let RECEIVER nodes to setup and subscribe ahead of expected messages being sent.
START_PUBLISHING_AFTER=60

# Define number of messages to be sent by each publisher node.
# Set 0 for infinite number of messages
NUM_MESSAGES=100

# ms delay between messages - when setting this consider RLN if applied to the network use will use.
DELAY_MESSAGES=1000

# Define message size range in bytes - publisher node will randomly generate message size between these values.
MIN_MESSAGE_SIZE=15Kb
MAX_MESSAGE_SIZE=145Kb


# You can define service peers for publishers and receivers if you know ahead the exact peers. Specify either with multiaddress or ENR.
#LIGHTPUSH_SERVICE_PEER=
#FILTER_SERVICE_PEER=

# ...or you can define bootstrap to locate service peers on the network, specify either with multiaddress or ENR.
#LIGHTPUSH_BOOTSTRAP=
#FILTER_BOOTSTRAP=

# Predefined values for different fleets - or set according to your needs
## for wakusim
#PUBSUB=/waku/2/rs/66/0
#CONTENT_TOPIC=/tester/2/light-pubsub-test/wakusim
#CLUSTER_ID=66

## for status.prod
#PUBSUB=/waku/2/rs/16/32
#CONTENT_TOPIC=/tester/2/light-pubsub-test/fleet
#CLUSTER_ID=16

## for status.staging
#PUBSUB=/waku/2/rs/16/32
#CONTENT_TOPIC=/tester/2/light-pubsub-test/fleet
#CLUSTER_ID=16

## for TWN/waku.sandbox
#PUBSUB=/waku/2/rs/1/4
#CONTENT_TOPIC=/tester/2/light-pubsub-test/twn
#CLUSTER_ID=1