v3.1.2

Bugfix release providing better support of EUDAQ>=1.7

Tested in November 2018 (DEPFET test beam at DESY II)

• Compatible with up to 31bit trigger number (sending 32 clock cycles to TLU)
• Fixed event building when EUDAQ TLU sends fake triggers (EUDAQ TLU firmware issue)

v2.2.2

Bugfix release providing better support of EUDAQ>=1.7

Tested in November 2018 (DEPFET test beam at DESY II)

• Compatible with up to 31bit trigger number (sending 32 clock cycles to TLU)
• Fixed event building when EUDAQ TLU sends fake triggers (EUDAQ TLU firmware issue)

v3.1.1

• Compatibility with latest Anaconda Python
• Compatibility with basil>=2.4.12
• Compatibility with EUDAQ>=1.7
• Ignoring RX errors in hot pixel tuning
• Fixed ExtTriggerScan got stucked when run a second time
• Fixed TLU tuning script
• Fixed plotting issues in case of no data
• Fixed not writing remaining data in FIFO
• Added general configure_fe and reset_fe run configuration parameter
• Updated GDAC tuning algorithm to reliably tune to desired threshold value
• Many other cleanups and smaller improvements

v2.2.1

This release is providing single chip support only!

• Compatibility with latest Anaconda Python
• Compatibility with basil>=2.4.12
• Compatibility with EUDAQ>=1.7
• Ignoring RX errors in hot pixel tuning
• Fixed TLU tuning script
• Fixed plotting issues in case of no data
• Fixed not writing remaining data in FIFO
• Added general configure_fe and reset_fe run configuration parameter
• Updated GDAC tuning algorithm to reliably tune to desired threshold value
• Many other cleanups and smaller improvements

v3.1.0

• adding context manager to Fei4RunBase to manage resource
• adding firmware for SHiP experiment
• keeping TLU/TRIGGER FSM busy when RX FIFO is not empty (all firmwares)
• adding write intervals to reduce disk usage
• fixing threshold baseline tuning and standard GDAC tuning
• fixing IPython issues with pyplot
• adjusting search paths for configuration files
• adding no data timeout for each FEI4 detector
• fixing many other issues and annoyances
• code cleanup (firmware and software)

v2.2.0

• using FIFO readout module from pyBAR v3.x.
• using write intervals to reduce disk usage
• fixing threshold baseline tuning and standard GDAC tuning
• fixing IPython issues with pyplot (remove pyplot)
• adjusting search paths for configuration files
• fixing many other issues and annoyances
• code cleanup

v2.1.1

• fixing TLU FSM was not enabled

v3.0.2

• cleanup
• remove Mimosa26 support from pyBAR -> https://github.com/SiLab-Bonn/pymosa
• fix online monitor
• fix default scan parameters for some scans
• enable threading by default while tuning

v3.0.1

• fixing RX reset and preserving register settings

v3.0.0

• supporting multiple readout boards
• supporting multi-chip modules (e.g., single, dual, quad module, and any combination of those)
• supporting parallel tuning of modules attached to individual TX (CMD) lines
• supporting multiple trigger inputs
• preserving scan/tune/calibration scripts