The DDR Test Firmware for LicheeTang20K.
GOWIN FPGA IDE V1.9.8.05
8-bit data, 1 stop bit, no parity, 115200 baud
Perform Reset Every 100s.
The fill rate and the check rate is limited by the LFSR, whose output rate is about 12MBps.
For a 1Gbits version, each fill/check stage consumes about 11s.
And for a 2Gbits version, each fill/check stage consumes about 22s.
Perform Reset
Auto Reset Every 100s
Init Complete
DDR Size: 1G
Begin to Fill
Fill Stage 1 Finished
Begin to Check Stage 1
Check Stage 1 Finished without Mismatch
Begin to Fill Stage 2
Fill Stage 2 Finished
Begin to Check Stage 2
Check Stage 2 Finished without Mismatch
Test Finished
In this firmware, the DDR3 interface belongs to Gowin, and is limited to be used in the GOWIN FPGA Designer.
In the branch slowDDR3, there is a open source DDR3 interface.
The Gowin DDR3 IP is faster than the slowDDR3 and larger than it.
If you wish to use the slowDDR3, please checkout to slowDDR3 branch.
This DDR3 IP runs at DDR-800.
Its maxium read/write rate is about 11,000MBits/s (when using 64 bursts).
The slowDDR3 runs at DDR-80.
Its write rate is about 240Mbits/s and the read rate is about 300Mbits/s.
Gowin DDR3 IP consumes 1288 Regs, 1363 LUTs, 102 ALUs, 8 BSRAMs and 110 SSRAMs.
While slowDDR3 consumes 147 Regs and 216 LUTs.
