An implementation of a wireless Klipper status display on an ESP32 + screen. Uses Moonraker to fetch data.
A simple and cheap solution to use a dedicated screen with Klipper, a 3d printing Firmware.
A ESP32-2432S028R is required to run this project. You can find out where to buy these on the "ESP32 Cheap Yellow Display" repository.
- View printer status
- View print progress and print statistics
- Start a print
- (When the printer is idle) move the printer
- (During a print) set fan speed, flow rate, speed and z offset
- Manage temperature
- Extrude/Retract filament
- Execute predefined gcode macros
- Toggle Moonraker power devices
- OTA updates
- Serial console over USB (115200 8n1, echo off, LF/LF)
On initial install, all data should be wiped. On updates, data should be able to be kept without issues.
When there is an update available, a button in the settings will appear that can be pressed to update. If automatic updates are preferred, there is a toggle in the settings to automatically update. This will right after connecting to wifi update the screen.
If you found this project helpful, please consider a donation to my Ko-Fi. It would help out a lot in the development of this project, due to the need to buy the screens.
Thank you!
(Quite literally shots of the screen. I'm sorry)
| - | - |
|---|---|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
- xtouch
- ESP32-Cheap-Yellow-Display
- OperatorB for the ESP32-3248S035C display driver
- esp32-smartdisplay