Parts to 3D Print

Most parts will work with the following print settings:

• PLA
• No supports
• 0.2mm layer height
• 6 perimeter layers (This is especially critical for parts that have heat-set inserts)
• 20% infill
• printable in the provided orientations.
• 2-3mm brim recommended, but not required

However, exceptions do exist! Please check the breakdown below for exceptions.

Note that parts that peel off the bed with a small curl cannot be used. They must stick to the bed such that they remain flat.

Other materials, such as PETG, may also work. We welcome feedback on various materials if others find them successful.

Frame Printed Parts and Quantities

• 1x back_z_panel.STL
• 2x belt_clasp.STL
• 1x compact_leadscrew_retainer.STL
• 4x corner_foot_plate.STL
• 1x front_left_bed_coupling_lift.STL
• 1x front_left_z_panel.STL
• 1x front_right_bed_coupling_lift.STL
• 1x front_right_z_panel.STL
• 1x left_corner_plate.STL
  • print with support material
• 1x left_motor_plate.STL
• 4x printed_pulley_spacer.STL
• 1x rear_bed_coupling_lift.STL
• 1x right_corner_plate.STL
  • print with support material
• 1x right_motor_plate.STL
• 1x short_motor_corner_plate_spacer.STL
• 2x small_leadscrew_retainer.STL
• 1x tall_motor_corner_plate_spacer.STL
• 3x z_motor_offset_plate.STL
• 3x z_thrust_bearing_spacer.STL

Extruder-Specific Frame Parts

• 1x ooze_wiper.STL per tool
• 1x tool_cable_management_bracket.STL per tool
• 1x parking_post_base_55mm.STL per tool
• 1x tool_holder_55mm.STL per tool

Toolchanger Parts and Quantities

• 1x carriage_back_plate.STL
• 1x carriage_center_plate.STL
• 1x carriage_coupler_plate.STL
• 1x carriage_pulley.STL
• 1x fixed_half_pulley.STL
• 1x floating_half_pulley.STL
  • print with support material
• 1x lock_actuator_base_plate.STL
• 1x lock_actuator_motor_clip.STL
• 1x spring_guide_anchor_block.STL

Fixture Parts and Quantities

• 1x coupling_plate_pin_insertion_fixture.STL
• 1x z_lift_pin_insertion_fixture.STL
• 1x z_lift_spring_pin_insertion_fixture.STL
• 8x outer_frame_squaring_plate.STL