Introduction

What's the simplest way to check vibration with Arduino? Just vibrate this sensor,it is designed by PCBWay team and FizzyStudio team. Arduino can receive a digital signal. It's easy to acount and program in Arduino. Despite it's simple, you can make full use of it with creative thinking, like step counting, Crash warning light and so on.

Specification

• Wide voltage range from 3.3V to 5V
• Standard assembling structure (two 3mm diameter holes with multiple of 5mm as distance from center)
• Easily recognitive interfaces of sensors ("A" for analog and "D" for digital)
• Icons to simplely illustrate sensor function
• High quality connector
• Immersion gold surface
• IO Type: Digital
• Switch life: up to 10 million seconds
• Open circuit resistance: 10Mohm
• Supply Voltage: 3.3V to 5V
• Interface: Digital
• Size:22x30mm

Tutorial

Connection Diagram

Sample Code

#define SensorLED   13
//Connect the sensor to digital Pin 3 which is Interrupts 1.
#define SensorINPUT  3  

unsigned char state = 0;

void setup() {
  pinMode(SensorLED, OUTPUT);
  pinMode(SensorINPUT, INPUT);
  //Trigger the blink function when the falling edge is detected
  attachInterrupt(1, blink, FALLING);  
}

void loop() {
  if (state != 0) {
    state = 0;
    digitalWrite(SensorLED, HIGH);
    delay(500);
  } 
  else
    digitalWrite(SensorLED, LOW);
}

//Interrupts function  
void blink() {
    state++;
}

Result

As shown in figure connection , plug LED and lay a finger on Digital Vibration Sensor , LED will be lightened