Optional Parts

Over time, a few optional parts were released. The files for these parts can be found in the latest release.

The parts are added to the assembly A09_ExoMy_with_Addons.SLDASM and can be manufactured using the instructions bellow.

If you design an addition to ExoMy, share it with use as described in the Contribution Guidelines and we'll add to the list here.

Bow Tie

Creator: Tim Wiese

Files:

• A07_Neck_Decoration
• P35_Neck_Clip
• P36_Bow_Tie

The bow tie gives ExoMy the most classy look. It can be printed in single color or multi color as described in the printing instructions.

Based on an original design by Tadeusz Sliwinski

Hat Rack

Creator: Miro Voellmy

Files:

• P34_Hat_Rack

The hat rack keeps the table clean and your hat brake free.

Wheel Sleeves

Creator: Tim Wiese

Files:

• P37_Wheel_Sleeve

The wheels of ExoMy are designed to perform optimally on loose terrain such as soil, sand, gravel or rocks. However, for operations on a hard floor a smoother and softer rolling surface is preferred.

The tire sleeve add-on can be printed using flexible filament. For assembly, the sleeves can simply be slid over the wheels.

Tips for printing with flexible filament

• Tested filaments: Formfutura FlexiFil & RS PRO FLEX 45
• Material: TPC (Thermoplastic Co-Polyester)
• Shore hardness: 45D

For good elasticity, infill density should be set to around 20 %. TPC requires a higher print and build plate temperature than PLA. Retraction should be disabled to avoid material grinding. Print speed should be slow to avoid clogging. Print cooling might need to be disabled to avoid detaching of prints.

Cura settings

• Infill Density: 20 %
• Printing Temperature: 250 °C
• Build Plate Temperature: 100 °C
• Enable Retraction: False
• Print Speed: max. 40 mm/s
• Enable Print Cooling: False