-
Notifications
You must be signed in to change notification settings - Fork 426
P3X VPS Module board
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
The Visual Positioning System board contains a camera and a sonar. It is able to stabilize position of the drone indoors and in situations where GPS isn't available. It only works at low altitudes.
The known variants have only minor differences.
Marking | Overview |
---|---|
P00903.T2 | |
P00903.T3 |
Marking | Amt. | Pkg. | Function | Specification |
---|---|---|---|---|
KJE C6 | 2 | |||
LFW 55 | 2 | |||
BR4 | 4 | Philips BSR33 Si PNP transistor; Uce 80V, Ic 1A | ||
C65 | 1 | |||
3PEAK TP2274 KAEh | 1 | TP2274 - 36V, 7MHz Bandwidth, RRO Quad Op‐amps | description | |
M058ZDN 524AD 2521B033 | 1 | Nuvoton M051 Series MCU with ARM Cortex-M0 core | description | |
ARM2 STM32F 407IGHb 78AEF VQ PHI | 1 | High-performance foundation line, ARM Cortex-M4 core with DSP and FPU, 1 Mbyte Flash, 168 MHz CPU, ART Accelerator, Ethernet, FSMC | description | |
T120 MfNA | 1 | Quartz oscillator, 12MHz | ||
INVENSENSE MPU-6050 D4F971L81 EL T530 E | 1 | TDK Six-Axis (Gyro + Accelerometer) MEMS MotionTracking Devices | description | |
CYY TYF 5327 | 1 | |||
W1A 55 | 1 | PMST3904 NPN switching transistor | description |
Chips | Firmware | Description |
---|---|---|
unknown | m1700 | Camera positioning measurement firmware. |
unknown | m1701 | Sonar altitude measurement firmware. |
Connectors on the board are:
Marking | Overview |
---|---|
4-pin ribbon cable con. | Ribbon cable connector |
The following service pads exist on this board:
Marking | Overview |
---|---|
3V3 | Power supply 3.3V. |
GND | |
SD_D0 | |
SD_D1 | |
SD_D2 | |
SD_D3 | |
VCC_TX30 | |
GND | |
ULTRA_RXD | |
ULTRA_TXD | |
5V | Input power supply 5V. |
GND | |
3V3 | |
GND | |
U6_TXD | UART interface 6, transmit. |
U6_RXD | UART interface 6, receive. |
DEBUG_TXD | |
COMP_NEG | |
POT_R6 | |
KA | |
TICE_CLK | |
TICE_DAT | |
VCC_AMP | |
GND | |
U2_TX | UART interface 2, transmit. |
U2_RX | UART interface 2, receive. |
ART3_TX | |
ART3_RX | |
GND | |
SWPIO | |
SWLK | |
PWM | |
U4_RX | UART interface 4, receive. |
U4_TX | UART interface 4, transmit. |
VAA_PIX | |
1V5 | Power supply 1.5V. |
Top of a T2 board:
Bottom of the T2 board:
Top of a T3 board:
Bottom of the T3 board:
Top of another T3 board:
Bottom of the T3 board:
Top of a T3 green coated board:
Bottom of the T3 green coated board:
flowchart LR
Ribbon-ESC((Ribbon<br/>to ESC<br/>Center))
Ribbon-ESC-- UART<br/>DUML ----VPS-MCU
subgraph VPS Module
VPS-MCU[STM32F407<br/>VPS MCU]
TOF-Driver[M058ZDN uC<br/>ToF driver<br/>ARM Cortex-M0]
TOF-Driver-Xlat(quartz<br/>oscillator)
TOF-Comparator[Comparator]
VPS-Accel-Gyro[MPU-6050<br/>accelerometer<br/>gyroscope]
VPS-Camera[camera<br/>sensor]
TOF-Spk((SPK))
TOF-Mic((MIC))
TOF-Out-Switch(Output<br/>switches)
TOF-Inp-Amp[Input<br/>amps]
TOF-Out-Switch---TOF-Spk
TOF-Comparator---TOF-Inp-Amp
TOF-Comparator---TOF-Out-Switch
TOF-Inp-Amp---TOF-Mic
TOF-Driver---TOF-Comparator
TOF-Driver---TOF-Out-Switch
TOF-Driver-Xlat---TOF-Driver
TOF-Driver-Xlat---VPS-MCU
VPS-MCU---TOF-Driver
VPS-MCU---VPS-Accel-Gyro
VPS-MCU------VPS-Camera
end
No schematics available.
This page is created by drone enthusiasts for drone enthusiasts.
If you see a mistake, or you know more about specific subject, or you see an area for improvement for the wiki - create an issue in this project and attach your patch (or describe the change you propose).